-
Junior Member
- Rep Power
- 0
- Reputation
- 10
Comnav siren when arming and disarming
Hi I have a hills nx4 alarm and have just installed a comnav board in it, had to reset the alarm due to installer code. The comnav is working fine now but I have an issue when I arm and disarm the alarm the siren goes on for a few seconds. Doesnt hapen when using the keypad only the phone app or browser. The keypad I have is a touchnav. Does anyone know how to turn it off or for it just to chirp instead of sounding like the alarm ks going off. Also how do I change the installer code on a touchnav from default, all the manuals I have read are for a normal keypad.
Thanks
-
Junior Member
- Rep Power
- 0
- Reputation
- 10
Managed to change the installer code now i just need to figure out the siren setting
Sent from my SM-G988B using Tapatalk
Go to Feature 22, Segment 1, turn off option 8. Siren blast for key-switch and wireless arming.
Junior Member
- Rep Power
- 0
- Reputation
- 10
Hi
I have tried changing that setting but i still get the siren blasting
Any other sugestions you could think of
Sent from my SM-G988B using Tapatalk
hmm No.
So it's a NX4? Not a Reliance 8? What year board do you think it is or when was it installed?
Junior Member
- Rep Power
- 0
- Reputation
- 10
Hi
It was installed in 2017
Yes its a nx4
It looks like in the instalation manual for the nx4 that option is the same though
Sent from my SM-G988B using Tapatalk
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks