-
Junior Member
- Rep Power
- 0
- Reputation
- 10
Connecting External Siren and Strobe to Risco lightsys panel.
In Risco lightsys alarm panel there is only two ports (Bell/LS)to connect the Piezo or the internal screamer.
How to connect the external siren and the stobe?
I have seen technicians joining the external
siren+internal siren+Strobe to Bell/LS port. which is not ideal because the external siren will keep on going off till correct code is entered. and I think the external siren should go off for few minutes then only the internal siren Piezo and the strobe should should be triggered till the correct code entered.
-
If you read the manual what you are asking is in there, installed plenty of these and the sirens only went for 4 minutes and the strobes until a code was entered.
Read the manual and you will learn..
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks