About 5 houses from my home a 3G and 4G Tower was reconfigured to also have 5G Last and this year
I have Installed Satellite dishes since 1985 first in the USA then I moved to Australia have put in many C-Band and Ku-Band antennas until 6 years ago when I lost a right foot below the knee. Can walk now but can't climb ladders but for myself I still do things slower.
I live south of Brisbane Australia about 15 miles and had a 2.3 meter mesh dish with a Zinwell C-band LNB which worked on Intelsat I-19 166E good but since they started 5G test and now regular transmissions I lost many transponders. So while looking why I found out that some had good signal using a SatKing C-BAND 5G FILTER LNBF model SKU-3103. I don't sell these this only a report on how it worked.
So after buying this new LNBF I was not happy with how the LNBF fitted into the LNB holder so it would not fit into the Zinwell C-Band LNBF holder so I gently enlarged the old holder so the fit was snug and easier to adjust. I aimed with a meter and got a much stronger signal than the Zinwell. Hooked up to the reciever and got all on I-19 166E Even NZTV which can now be recieved with a Biss reciever. And FTA pictures are clear and sharp and because of Covid19 Phillapine canels are free now and all sharp pictures.
I hope this post help fellow members for 5G is going all over the world and I see that there are problems with the older LNB's that must of let in side signals.
Now my next project is fitting one of these To my 10 foot dish used for Circular Polarisation which I have used a Zinwell C-Band LNB and lost signals on NSS9 and another satalitte(don't worry I know I can't spell at times)
Look Here -> |
Eventually this 5 g shit will hit out area as we have a tower about 600M away. I will need one like yours with two LNB ports not one also need two of the orthomode ones. Where did you buy it from?
Last edited by Mr 672A; 19-05-20 at 10:57 AM.
If you intend on using your old existing feed horns, These Pauxis 5G LNB's branded Satking and earlier Mediastar's require filing the center hole of the feedhorns, I find the thin feed horn scalar ring which comes with the LNB degrading the performance.
The Superfeed purchased a while ago increased the MER by 1dB. Center hole has removable tabs to fit any LNB.. no filing was needed.
Last edited by B52; 17-11-20 at 02:49 PM.
..
Last edited by B52; 18-02-21 at 04:53 PM.
And so the saga continues, you replace the old LNB with a 5G filtered LNB, the Spanish couple in their 90th are happy and you even got paid. 2 weeks later they call, the dropouts returned, you try other brands of 5G's but no joy.. Sounds familiar ?
you look up and see the guys in the cherry picker are at it on the tower near by. Check the signal on the spec and you can see a few unwelcomed spikes emerging from 3700MHz so now we need an LNB on which the gain drops to -60dB at 3750Mhz meaning the LNB will work from 3.8 to 4.2 GHz..
Last edited by B52; 25-02-21 at 01:33 AM.
sounds to me like some one needs to work out some wave lengths and then start building a lnb with individual filters and its not that hard to do your self , you need to know the interfering frequency and bandwidth and polarity then tap some screws into the feed horn at the appropriate distance from the 75 ohm bar in the feed horn throat before the antenna (V OR HOZ) THE DIAMETER OF THE SCREWS WILL BE AROUND 3-4 MM and spaced between 0.20-0.25 wavelengths from the antenna . It is critical that the internal antenna is not to long so it works only on the intended band so it may be necessary to trim its length to the 3.8 ghz frequency . This will have the effect of raising the resonant frequency and provide more isolation from the interfering frequency IE the further away the higher the impedance and more isolation . practice putting a ship in a bottle skills lol Remember that the manufacturers put it together so you can dismantle it . the theory is that you introduce antennas in the throat which are short circuited therefore are a attenuation on the unwanted frequency the more antennas the more the sucking out of the frequency , being at about quarter wave apart it will work on both the e and m waves so a min of two are required four is better as they add together . There is another way but its very fiddly that is to put half wave dipoles across the center line of the throat but the mounting is awkward as no metal can be involved in the mounts and also no movement as it will upset the wanted freq as well and setting the distances is almost impossible , thats enough thinking for today cheers don
As per the allocated 5G in the 3.6Ghz band. This band is 3575-3700 MHz. Recently in some areas they have activated on or near enough to 3700Mhz
hinekadon (19-05-21)
Both are made by Pauxis China.
The Blue Mediastar on Asia 5, EU Bouquet 3860 V. Turning the LNB V/H orientation so that 3860 comes on Horizontal got acceptable outcome. Blind rescan required. Also one cable solution with 5G filter not too bad.
Since August last year I have done many 5G changeovers for Asiasat 5, Italian, Portuguese and Spanish audience They all worked great until about 2 months ago when further 5G upgrades are being rolled out. Some sites are OK other sites work during the evening, I guess less 5G traffic and some sites have gone for IPTV cause nothing worked.
Spanish on 3840 H very challenging. Every site is different, dishes mounted high on the roof are more vulnerable, so is the distance to the telco tower.
Last edited by B52; 20-05-21 at 12:38 AM.
hos here (20-05-21)
Yeah, I managed to get RAI International by lowering a dish to the ground and below fence line for an old Italian couple.
TVE with FEC of 5/6 is particularly difficult. Getting worse as more 5G turned on.
Not tried the one cable solution yet.
But so far the improvements with LNBF with 5G filter are pretty useless.
Makes improvements but not enough to keep the picture fully stable.
Also people don't want to shift a dish with no guarantees and only a chance it might work.
I was given a dual SatKing 5G filter like the above single to test today.
On my spectro it completely removed the 5G interference.
I got a good stable picture and no bouncing quality so that is pretty pleasing.
Dunno how long it will stay gone for...
If I stick a std LNB no 5G filter on the spectro with no dish and just point the LNB in my hand at the tower I get a whopping big 5G peak.
No peak doing the same with the SatKing with 5G filter.
I tried one in a different location this week and the 5G signal must be stronger and was not completely gone.
The meter held a signal ok but the picture stuttered along a little bit.
On the customers Strong Rx the picture was fine though.
How long it says that way is anyone's guess.
If you really want fun and games put the dish on vinasat at 132E or Laosat at 128.5E which are active 3400 to 3600 mhz
Junior Member
Junior Member
Bookmarks