Bosch B426-M is the IP module for the app.
Your panel board also needs to be version 2.0.0 firmware or above.
Hi,
I have bosch 2000, i need arm, disarm and open/close garage door via RSC+ app on iphone, which device i need to buy to connect to panel
Thanks
Look Here -> |
Bosch B426-M is the IP module for the app.
Your panel board also needs to be version 2.0.0 firmware or above.
Last edited by secure; 16-08-20 at 11:53 PM.
Thanks secure, and How to run connect cable from panel to garage door
I'm not sure, as I haven't linked them to garage door before. It's to do with how the output is programmed, to make it show up in the app.
Possibly re-program the smoke output and link to a relay to trigger garage door.
Done this at my house
Run and fig 8 or 4 core cable from panel to garage door (most usually have options on the door motors).
You need to use the onboard relay (output4) on the board which does the internal siren and use that for the garage door.
Contacts will be COM and NO
You then need to put the internal pieze on Output 2 and program output 2 to become what Output 4 was, or you could double with the external siren if you wanted too.
In installer mode to get garage door working enter the following
454 - 2 *#
455 – 8*#
456 – 3*#
457 – 2*#
458 – 0*#
459 – 2*#
960#
Ensure the jumper pin is set to dry contact on the board itself , you should see a GND and 12V option.
In the app if you click on outputs you should see "output 1" and if you click "turn on" should operate the relay.
It works 90% of the time , if you don't see it go out and back into the app and should be there, also make sure the RSC app is up to date.
Hope this helps.
Last edited by Midnight1982; 25-08-20 at 11:00 PM.
Bookmarks