Results 1 to 2 of 2

Thread: Rose metal solder

  1. #1
    Senior Member

    Join Date
    Jan 2008
    Location
    A rock in the ocean
    Posts
    698
    Thanks
    81
    Thanked 120 Times in 69 Posts
    Rep Power
    246
    Reputation
    3056

    Default Rose metal solder

    Extending on a bit from my reworking BGA devices post...
    Have done a bit of practice in removing considerably larger BGA devices than I will ultimately need to work on, and it's going well so far. Cleaning up the PCB lands is a bit harder than first thought though - managed to pull one land off completely on my practice PCB. It probably was an unconnected pad, but I'd rather aim for perfection than mediocrity.

    I've seen a technique where the PCB lands are soldered with very low melting rose metal (90-ish degrees) to form an alloy with the solder already present on the PCB that has an overall lower melting point than the standard 180 degrees, and then remove with wick at a lower temperature.

    There's low melting point indium based solder, but that stuff melts around 150 degrees. Not a huge improvement over standard 60/40 at 180 degrees, hence the preference for 90 degree rose metal.

    Not having much luck finding a source of rose metal (sometimes called rose's metal) in Australia. Best I can find is some ebay suppliers out of Ukraine. Any hints on a supplier?



Look Here ->
  • #2
    Premium Member
    wotnot's Avatar
    Join Date
    Nov 2019
    Posts
    1,347
    Thanks
    536
    Thanked 1,154 Times in 619 Posts
    Rep Power
    523
    Reputation
    23090

    Default

    Rose metal alloy is 50% bismuth, 2528% lead and 2225% tin. Its melting point is between 94 and 98 C

    ...melting point 58C

    Chip-quik make a few different low melt solder alloys with different melting temps ...Mektronics stock most of them.

    It's not cheap stuff, so use it sparingly

  • The Following 4 Users Say Thank You to wotnot For This Useful Post:

    gordonwh40 (02-04-21),mitaux8030 (02-04-21),TVguy (02-04-21),VroomVroom (06-04-21)

  • Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •