Are you doing keyswitch via input terminal or by a zone input and using zone type 13?
Hi,
I have 3 area’s setup on my Bosch Sol 16p and recently added a keyswitch, however am unable to find where to trigger ALL area’s. At this stage the keyswitch only Arm/Disarms the one area.
Can anyone guide me where the setting for all area’s is?
Sent from my iPhone using Tapatalk
Look Here -> |
Are you doing keyswitch via input terminal or by a zone input and using zone type 13?
The only way might be to have a zone for each area. So to do 3 areas would need 3 zones.
eg. Could do area 1 and area 2 on zone 7 and 15 so keyswitch shorts both inputs at once when panel is zone doubled.
Menu 341 is set to 00 Latching ALL ON/OFF, in theory should be correct. Much like ARMing using the hold(ALL ON) button at the keypad to arm ALL areas.
Worse comes to worse move all zones into just the one area to make it less complicated…
Sent from my iPhone using Tapatalk
Bookmarks