there was a thread on the old forum about it.
I suggest check that the pins in the RJ45 connector are okay.
Then re-solder joints all over near the network IC in front left corner.
Anyone able to fix blown network ports on dm500?
Look Here -> |
there was a thread on the old forum about it.
I suggest check that the pins in the RJ45 connector are okay.
Then re-solder joints all over near the network IC in front left corner.
ok cheers!
Just a nob question if the network port is blown
is there a way of using the rs232 port instead
now be nice
When you do things right, people won't be sure that you have done anything at all
The network port on a 500c just blew tonight during a bad storm. The switch it was plugged into also went.
Is the 500c a write off now? I think it blew the cable amp it was plugged into also.
it is rooted.
ouch...I had the same problem...lost 3 dreams in one go, lightning struck the vacant block next door. I think both the missus and jumped through the roof.
Bookmarks