i have never been able to get lmedit to work i use ggedit instead that works well with gold and silvers
Hi All
I am trying to program a goldie using an Elvis, Multiprog and LMedit. I can load the pic and eeprom files OK but when I try to program the details to the card using LMedit i get the following error message (data interupted check card contacts). I have tried a number of goldies but get the same message on all of them. The cards are new. Am also running XP. Any suggestions would be appreciated.
Thanks
Nothing sucseeds like a canary
Look Here -> |
i have never been able to get lmedit to work i use ggedit instead that works well with gold and silvers
IF IT DONT WORK USE A BIGGER HAMMER
check your email mate and run runme.bat.
Are you using the following settings,
1, Phoenix (Mode)
2. 6 (MHZ)
3. 1 (or Com port you are using)
4. GGold (Card Type)
it should then read & write & load etc.....
but I have found that some cards refuse to be read for some reason,
I have a silver card that works perfectly in the STB but will not read in LMedit.
& another Silver card that reads no problems
Just a thought, Good Luck
Guys thanks for the responses. I now have it working. It appears it was missing an ocx file. Thanks to Guesty for the files.
Regards
Nothing sucseeds like a canary
hay flippy could you send e the files i have what i thought was all ocx file but who knows i might be missing one
IF IT DONT WORK USE A BIGGER HAMMER
WHich ocx file is missing, i could never get LM.Edit to run under XP but fine with 98
I've not had a problem running LMedit on XP SP3, with a Jaycar MII.
Well, once I got my MII sorted out that is
Thanks for the file OSIRUS . had the same files in my system32 folder, but now I know that LMEDIT doe's not like Mastera IV. I've tried lmedit with cas3 & all good.
Cheers
One more thing to try, is to place the .ocx files in the folder with the card reader/writer programs,
if the .ocx files are in the same folder as the program you don't have to place them in the System 32 folder & then register them,
e.g. Place,
1. Comdlg32.ocx
2. RICHTX32.OCX
3. MSCOMCTL.OCX
4. mscomm32.ocx
5. tabctl32.ocx
in the same folder as your FMCard & LMedit programs, (& then run the programs from here),
Also, GGedit requires the SaxComm8.ocx file
Also don't forget some cards are copy protected & cannot be read,
Perhaps you are right & LMedit don't work with the Mastera IV programmer, for some other reason (I have not used it)
Good Luck
Become a Premium Member and support the Austech Forum
Bookmarks