phoenix

[nfnovice]

I have a phoenix external serial on a 7000 running cccam

when I put my aurora card in - light blinks a bit then starts working (pics OK)
when I put the f0xte1 card in - no blink no nothing - card not detect

both cards work and show pics in the internal slot

I was thinking cccam setup most be ok because one card work in the phoenix

could it be physical rather than logical problem - like the f0xte1 card is not detected by hardware because its not hitting the card detect part of hardware ?

[z80]

speed is critical.

[nfnovice]

thanks z80
config file timing changes make no difference

switch on phoenix did the trick - must be timing
one way reads aurora - other way reads f0xte1
cheers

[LeroyPatrol]

You would have to have both the freq in your config file matching the freq you have your reader set to. Also I would of thought your aurora card would work at the same freq as your other card.

Leroy

[jonc]

try adding a fake boxkey line and see what happens

BOXKEY: /dev/sci0 00 00 00 00

[LeroyPatrol]

How does a fake boxkey entry help?

Leroy

[jonc]

How does a fake boxkey entry help?

Leroy

read the CCcam.cfg release notes and NDS cards, a simular thing applies to newcs and others

[nfnovice]

try adding a fake boxkey line and see what happens
BOXKEY: /dev/sci0 00 00 00 00

yep had the boxkey line in

BOXKEY: /dev/tts/0 00 00 00 00

Also I would of thought your aurora card would work at the same freq as your other card.

me too - found no difference regardless of cccam.cfg frequency settings - one card works with switch one way - other card works when switch is other way
even with no start of cccam or full restart
another play will have to happen when nobody here is gonna complain about stops and starts on viewing - back of the clock is good I guess