select com port hit reset and it will read your card but it wont read the emk as that needs to be logged then the emk sent to the card with 3.5.
read a bit more and use the search button
Hi guys, Im trying to read the EMK on my whitey using Gamma Card v3.5. My programmer Im using is a Jaycar MKII. When I insert my card and run the program the only button available is the reset button. I'm using a serial cable from an old modem. Could this be the problem?
Look Here -> |
select com port hit reset and it will read your card but it wont read the emk as that needs to be logged then the emk sent to the card with 3.5.
read a bit more and use the search button
actually it's the HSN I'm trying to read. I checked the serial cable and there is continuity between each of the 9 pins.
This is the screen I'm facing with.
stick your card in and hit reset and all will be revealed......
Leroy
Like diavolo said, check your comport
You might have to change that to 2 or 3
EDIT, Doh, problem solved.
That will teach me to open a thread and not reply till two hours later
Put card in reader then press RESET then you click on LOAD GAM and load gamma file the SEND TO CARD button will light up.
The other two SEND TO CARD buttons down the bottom light up after reset.
All sorted. Installed missing oxc file. Thanks badass for making me think outside the square
Yes not having ocx files would cause the problem.
Glad I could help.
Cheers Badass
thank you for the post .................
Bookmarks