mate you need to update your navcore from version 6 to version 8 tomtom wont see version 8 maps withe navcore 6 let tomtom home update your 910 and then patch the system file
This is my first time posting so please go easy on me. I have installed and patched version 815.2086 onto my TTGO 910 now when I check in HOME under Show contents of my go, under maps it shows map 815.2086 113mb. Then when I go to operate my TT it keeps on coming up "No Map" can someone be kind enough to explain as to what I am doing wrong? I did try before with version 720 and my TT would work fine in HOME but when I disconnected my TT and tried to use on its own not connected to PC it would say "No Maps" but connect it back to computer it would work in HOME again? This is my device as it is now with version 650.114 as I formatted and reinstalled backup.
Thanks Bryan
Last edited by aussiebryan; 23-05-09 at 03:06 PM.
Look Here -> |
mate you need to update your navcore from version 6 to version 8 tomtom wont see version 8 maps withe navcore 6 let tomtom home update your 910 and then patch the system file
IF IT DONT WORK USE A BIGGER HAMMER
G'day puca. I have gone to HOME and clicked on UPDATE and it says "Your device is up to date". I formatted like I said and reinstalled backup so running 650, but I also patched 720 using BENBSS V8 keygen and while in HOME I can choose which map to use which was 720. Then when I undock my TT and use, I only have one map which is the 650. Any suggestions?
yeah like i have said unless you install a version 8 navcore your 910 will not see the map what version of home are you running the latest is 2.6.3.1609 make sure your home is up to date then try and update your 910 the latest for it i think is navcore 8.30 i have put the link for download here
download both folders install them on you 910 use the system patcher that you used to make the dct file for the map rest you 910 and it will find your map
IF IT DONT WORK USE A BIGGER HAMMER
just found this thread here gives a full detail account on what to download and use to update your 910
IF IT DONT WORK USE A BIGGER HAMMER
Hi again Puca yeah I have HOME V2.6.3.1609. I have downloaded the 2 files you put links to and also went to the link on instructions. This is where I fall down as I cant find the ASR folder they refer to? All I have in zip files are what is shown in images. Any chance of a quick message as in a step by step guide? I know I must be getting close to it but cant seem to finish it off.
Its ok after many hours and lots of reformatting etc I managed to load navcore and update and run maps in my TT. Thanks for the help puca much appreciated. I think I will write up a step by step guide with images for other new users, so they dont have to spend many hours trying to suss it out.
Bookmarks