G'Day Cobbers,
It would seem that some are acquiring these without the Instructions, so;
As a general rule this applies to all the H to H Motors.
Known is that there are 30 and 40 degree bends in the rotor axle shaft.
The absolute criteria for a good installation is a PLUMB mast. (Vertical in all directions.)
It helps immensely, if you put a mast bracket on the mast to support the motor/dish assembly, so that you can swing it in Azimuth without it sliding down the mast.
If you find that you need further explanation, please post here.
Kindest Regards, " The Druid "...........
Look Here -> |
Thanks for this information beer4life, I now know what I've done wrong in the installation process.
Miracle that I'm getting any satellites at all, when the weather clears a bit I'll climb onto the roof with an adjustable ring spanner and make a few corrections.
Bookmarks