HX4700 upgraded to Mobile 6.1 No bluetooth

**Super Slim** · 07-06-09, 01:26 AM

I have just upgraded my Ipaq HX4700 to MS Mobile 6.1, from 2003 SE, so I can load Tom Tom 7 and use my Bluetooth GPS.
As soon as I start Bluetooth, I get an Error CTTRAYCE message that there is not enough Driver memory.

I have done a soft reset, and stopped all running programs, I have deleted a lot of outlook address, but the PIM file is 5.75 mb, down from 9.1 mb.

I have manually started BTtrayce.exe, then started Bluetooth, all with no success!

Is too large a program for my OLD HX4700?

Regards

Super Slim

**tedy bear** · 07-06-09, 05:28 PM

Read down the bottom of this thread.

**Super Slim** · 08-06-09, 05:01 PM

Dear Tedy Bear,

**Super Slim** · 08-06-09, 05:06 PM

Thanks, after reading the thread I did a hard boot and the bluetooth and speaker now work!!
I then used active syn to update my 2700 contacts(was 3000+) onto the HX4700, and bluetooth still works!!!!

I will now add TomTom 7 to see if that is the culprit!

**tedy bear** · 09-06-09, 09:07 AM

All you have to do is rename these two files BTSDKCE30.dll
BTCORELF.dll after you have installed Tomtom..

But you need a program called total commander to get access to them..