what software are you trying to use? and what are you trying to read? pic or eeprom
Hi there Guys,
I am mucking around with my jaycar programmer but I'm getting an error code 000h coming up.
I did a search on here but couldn't find anything on it. Does anyone have any ideas what it will be?
Thanks for you help in advance
Look Here -> |
what software are you trying to use? and what are you trying to read? pic or eeprom
Blown Humax 5400Z, Strong SRT 4658X, Strong 4663X and DM 518.
Hi there,
I have a gold card and I am reading the article in silicon chip about programming them.
I have download the operating system for it from maxking as it says in article but after erasing whatever was on the card then downloading it on the card it comes up with the error 000h
Arty
what programmer do you have? and what is the software called that you are trying to using?
Blown Humax 5400Z, Strong SRT 4658X, Strong 4663X and DM 518.
Hi there,
The programmer is the Jaycar KC5361 and the s/w is the icprog 1.06a
Regards,
Arty
Your not ticking the CP option are you?
What would you do if your server was stolen or failed beyond repair?
http://www.2000cn.com.au/shadowprotect.html
Hi there,
No CP is not ticked but WDT is. The jumper pins are both on 2-3. Is this correct for a goldy???
Arty
this is the same eorror message i am getting 0000h when using ic prog it happens when verifying regardless of cp or wdt ticked or unticked ive tried all combinations.
can anyone shed some light on this?
is there any way of getting a card working from blank just using fm card?
Try "invert data in" and/or "invert data out" in Hardware settings.
I am getting the same message with icprog using infinity usb "failed to verify at 0000h" while trying to code a silver
I can read the card no problems at all, I can erase the card no problems at all, I can blank the card no problems at all, but when it comes to verify, its a combination of failed to verify at 0000h or card is not blank, its really driving me farking crazy.
I'm running xp sp2, i have read previously that xp without sp updates should do the job but could never do it or run win98.
The other problem I have is in hardware settings of icprog there is a drop down box with a list of different card readers of which usb infinity isn't listed?
do I just leave it on jdm? I have honestly tried aall manner settings invert data ect, I als tried checking cpd, code protect off even the the oscillator selection LP, RX ect but without success.
would it be easier to try running the prog on win98?
Ok ..
I have IC-Prog 1.05E XP Pro SP2 & Mastera II in mode 1= Phoenix 3.5Mhz
I can read the goldies, erase, blank check & verify all OK.
Then use the wizard to start up & does th 1st part OK too, then it wants to load GF Gold v226 & has error "resetting card failed"
Am i using the wrong .hex file or just not doing a step correctly ???
just tried a silver in IC-Prog
can erase etc as well , go to program with 16f877v3_bootloader.hex & it has error
Programming fail at code address 0000h !
Bookmarks