Many thanks, Koshari.
Much appreciated.
Well done, SJG.
...and Welcome to the forum!!
Banned
I just noticed this older thread, I have similar problem with our same Dishlex unit. I was not able to find the link mentioned, I assume the overall layout of the site has changed and the reference to the link for the file (for the wiring diagram) is not longer active ?
Would be great if link could be provided again .
Thanks
Hi,
My DX302 is not heating water. Solder joints on heater relay are fine. Could anyone please send me wiring diagram? The link mentioned previously does not work anymore.
Thanks
I have the same issue with my DX302 not heating, i picked up a complete spare machine about 2 years ago and swapped the circuit board but it has no succumbed to the same problem.
Its an old machine and works fine apart from not heating.
Sent from my MAR-LX2 using Tapatalk
loanrangiel (07-06-20)
Check the solder on heater relay of the control box. In most cases the solder joints melt and once resoldered, it works fine. Unfortunately on my dishwasher solder joints are ok and the issue may be with tacho but I need wiring diagram to do thorough checks.
This might be helpful.... Electrolux Dx302 not heating...
Already tried this. I checked voltage at the heater connector that connects to relay and it checks bet 3-4 volts when the recirculating pump starts and increases to 240 volts about 10 secs after. So not sure what the exact issue is and that’s why I was looking for a wiring diagram or service manual
Bookmarks