They can be used as a Season Interface in conjunction with a BF430 , no use for anything else , all the logging programs of old dont interpret irdeto 2 properly
i just lashed out and bought one of these, can someone point me to a guide to get the most out of it pls.
Look Here -> |
They can be used as a Season Interface in conjunction with a BF430 , no use for anything else , all the logging programs of old dont interpret irdeto 2 properly
you can use them to keep you whitey cool.. picky back it in a strong or humax
or you can use wallbanger and try it with aurora as its ir1
the thin piece of pcb material can be difficult to buy.
use it to make a ripper season interface...
Why would the whitey be cooler in a season from a Humax when the voltages etc would be the same as if it was in the box?
The whitey does run cooler in a season from a Humax
why dont know but it allmost cold in mine
runs cooler besause its ventilated
a ripper is used to extract the gam files from a whitey
these are the best season around without fail , just wondering if anyone could tell me what are the active numbered wires in the 9 pin connector as i want to make up a nice long lead for mine using an old ethernet cable and a dick smith 9 pin connector i am pretty sure of 1, 2 , 3 and 5 but dont know the other one , bad eyes and beer dont mix
bringing this thread back to life as want some more info on this. besides the traffic logging of the card is there anything else these can be used for with aurora? can they fully emulate? any way of logging more than one card at a time? like the EMK's for multiple cards? will anything display the whole list of CHID's for each channel as most know each channel has more than one working CHID. any other software besides wallbanger? and if so what settings to get it to work it its not obvious.
---------------------------------------------------
3 x 90CM Hills Offset, 1.2M Aluminium Offset, 1.2M Offset,
1.7M Offset.
Bookmarks