you need to add this line to the cccam.cfg file in var/etc
N: xxx.xxx.xxx.xxx yyyyy uuuuuuu ppppp 01 02 03 04 05 06 07 08 09 10 11 12 13 14
x = ip address
y = port
u = username
p = password
Hi
just wondering how do i connect to a card sharing server?
1 - Box #1 is running PLI with mgcamd as the emulator , it connects to the CS server ok! works fine. Now i want to transfer that settings over to the new box (box #2) which is running gemini ...with CCcam204/NewCS
would it work or do i have to use mgcamd? which files should i config in box #2 (cccam)
Look Here -> |
you need to add this line to the cccam.cfg file in var/etc
N: xxx.xxx.xxx.xxx yyyyy uuuuuuu ppppp 01 02 03 04 05 06 07 08 09 10 11 12 13 14
x = ip address
y = port
u = username
p = password
dont say linux if i wanted it id install it
ahh i made mgcamd load via the bluepanel!
but im not sure which setting files is it using?
I thought mgcamd used
/var/keys/mg_cfg?
you need to get the string from the mg_cfg then put it into the cccam.cfg
dont say linux if i wanted it id install it
picture not stable, im thinking its the emulator, trying to configure mgcamd
currently can not get it to work
turn fast zapping off in the expert menu.
it could be the software or gemini firmware?
some guy was having the same problem...it was a software issue but for me im not sure
make sure the 2 boxes are using different username & passwords in NewCS.xml
The quieter you become, the more you are able to hear
ah I see, strangely enough i increase the number of hop's and it freezes less frequently.
MAC addresses are the same?
maybe, my box is a clone?
mg_cfg is only a config file for how mgcamd handles its emm,ecms & types of share etc.
mgcamd uses
var/keys
mg_cfg - settings
newcamd.list (shares)
var/tuxbox/config
newcamd.conf (also for shares)
you can use one or the other same as evocamd...
it also can use newcamd.conf or file in var/keys of similar name.
this is well documented everywhere .
Bookmarks