how to connect to card sharing server?

[revolver]

Hi
just wondering how do i connect to a card sharing server?

1 - Box #1 is running PLI with mgcamd as the emulator , it connects to the CS server ok! works fine. Now i want to transfer that settings over to the new box (box #2) which is running gemini ...with CCcam204/NewCS
would it work or do i have to use mgcamd? which files should i config in box #2 (cccam)

[fandtm666]

you need to add this line to the cccam.cfg file in var/etc

N: xxx.xxx.xxx.xxx yyyyy uuuuuuu ppppp 01 02 03 04 05 06 07 08 09 10 11 12 13 14

x = ip address
y = port
u = username
p = password

[revolver]

ahh i made mgcamd load via the bluepanel!

but im not sure which setting files is it using?

[revolver]

I thought mgcamd used

/var/keys/mg_cfg?

[revolver]

you need to add this line to the cccam.cfg file in var/etc

N: xxx.xxx.xxx.xxx yyyyy uuuuuuu ppppp 01 02 03 04 05 06 07 08 09 10 11 12 13 14

x = ip address
y = port
u = username
p = password

thanks alot it works!, what about if i want to use mgcamd?

[fandtm666]

you need to get the string from the mg_cfg then put it into the cccam.cfg

[revolver]

you need to get the string from the mg_cfg then put it into the cccam.cfg

is that because gemini configs it differently?

[revolver]

picture not stable, im thinking its the emulator, trying to configure mgcamd
currently can not get it to work

[z80]

turn fast zapping off in the expert menu.

[revolver]

turn fast zapping off in the expert menu.

I tired this, then rebooted and still the same problem
once in a while it freezes...then it comes back on again.

i have no idea anymore ... im thinking maybe its the emu or emu setting but im not sure

[revolver]

it could be the software or gemini firmware?

some guy was having the same problem...it was a software issue but for me im not sure

[STI02]

make sure the 2 boxes are using different username & passwords in NewCS.xml

[revolver]

make sure the 2 boxes are using different username & passwords in NewCS.xml

could more than 1 client have the same username/password?

[LeroyPatrol]

could more than 1 client have the same username/password?

Nope......guessing that's your prob

[STI02]

A definite NO

could more than 1 client have the same username/password?

[revolver]

ah I see, strangely enough i increase the number of hop's and it freezes less frequently.

[z80]

MAC addresses are the same?

[revolver]

maybe, my box is a clone?

[davo]

mg_cfg is only a config file for how mgcamd handles its emm,ecms & types of share etc.

mgcamd uses

var/keys
mg_cfg - settings
newcamd.list (shares)

var/tuxbox/config
newcamd.conf (also for shares)

you can use one or the other same as evocamd...

it also can use newcamd.conf or file in var/keys of similar name.

this is well documented everywhere .