Try this,change Mode to single then input 11300
hi all.
im in need of a little help.
My Mediastar D-10 when a little haywire. i did a factory reset.
I have to put the lnb settings back in.
As i havent put them in for a very long time, can someone please help with the settings. I have a dual lnb pointed at C1
I have the following:
Lnb: A
Enable: Yest
Power: On
Mode: Dual
Low frequency ?????
High frequency ?????
Switch frequency ?????
Im pretty sure its a 11300 lnb, but when i enter that into the frequency then enter aurora details the picture goes from normal to scrambly.
any help really appreciated = and i have a valid card.
thanks
Look Here -> |
Try this,change Mode to single then input 11300
Then look at buying a new - modern decoder, the D10 is older than the Pyramids.
5th Wyking Panzer Division
thanks, did that today. it was almost dead.
Got a
Strong 4653x
thanks guys anyways
Bookmarks