Hey Guys,
Im trying to manually update my sellers EMK but am struggling i cant seem to get anything up about the card.
I have been trying to use GUP.
Will appreciate any help given
Cheers
DM600 & 85cm Motorised Dish
Look Here -> |
pm sent
If you feed ducks at a pond, chances are your bound to feed a goose or two without even knowing it.
sorry I am a total newbie here with cards (and not trying to pretend anything other than that) but did you run it through fmcard? (i say that WITH limited knowledge).... i am sure a guru will assist, having said that panda did detect a valid ATR as well as fmcard, all the rest where dodgy...
Last edited by z1gg33; 01-12-09 at 08:38 PM.
If you feed ducks at a pond, chances are your bound to feed a goose or two without even knowing it.
you need phoienx mod try the elvis software
z1gg33 (01-12-09)
z1gg33 (01-12-09)
When ever i try and use ElvisCC it comes up with
" Failed to send command to elvis
Check power and ensure other applications are not connected to the port"
I know the power is fine bought a new battery today is there anyway i can ensure other applications are not connected to the port?
DM600 & 85cm Motorised Dish
try multiprog
rewstar (01-12-09)
yes as mickc said you need multiprog to power up elvis and set to phoenix and 3.5
IF IT DONT WORK USE A BIGGER HAMMER
rewstar (01-12-09)
using which tab?
Thanks
yahah
got my ATR
used Multiprog and using the MPset tab pressed Phoenix 3.58MHz
Leaving Multiprog open
Then went to GUP and pressed reset and it read my ATR.
Cheers Guys now the next step... will prob be back on here in an hour or two when i cant figure it out again haha
Last edited by rewstar; 01-12-09 at 09:03 PM.
DM600 & 85cm Motorised Dish
Ok i got my EMK from my HSN (thanks INFO)
And it looks something like this
CBS1S2S300000XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXX
Do i just copy this whole line and put it in GUP loader?
If so which section do i put it in?
-String to Send to card
or
-Logged data to Send to card
im assuming logged data but i want to be sure.
Cheers
DM600 & 85cm Motorised Dish
rewstar (01-12-09)
Bookmarks