ELVIS Help

[rewstar]

Hey Guys,

Im trying to manually update my sellers EMK but am struggling i cant seem to get anything up about the card.
I have been trying to use GUP.

Will appreciate any help given

Cheers

[beer4life]

Hey Guys,

Im trying to manually update my sellers EMK but am struggling i cant seem to get anything up about the card.
I have been trying to use GUP.

Will appreciate any help given

Cheers

Jaycar/Phoenix/3.5MHz/panda

[rewstar]

Jaycar/Phoenix/3.5MHz/panda

ok cheers do u have a link to the panda loader?
Have been looking for it, i know its on this forum somewhere

[z1gg33]

pm sent

[rewstar]

pm sent

thanks


Panda comes up with "No ATR"

Any ideas Cheers

[z1gg33]

sorry I am a total newbie here with cards (and not trying to pretend anything other than that) but did you run it through fmcard? (i say that WITH limited knowledge).... i am sure a guru will assist, having said that panda did detect a valid ATR as well as fmcard, all the rest where dodgy...

[rewstar]

sorry I am a total newbie here with cards (and not trying to pretend anything other than that) but did you run it through fmcard? (WITH limited knowledge).... i am sure a guru will assist

I have in just the mouse tab with Connect and it comes us with the following

unknown ATR

and then on the side "Card Error" is red.

Do i need to change any of the settings beside the Port number?

[mickc]

you need phoienx mod try the elvis software

[beer4life]

ok cheers do u have a link to the panda loader?
Have been looking for it, i know its on this forum somewhere

I think this is the one.

[rewstar]

you need phoienx mod try the elvis software

When ever i try and use ElvisCC it comes up with

" Failed to send command to elvis
Check power and ensure other applications are not connected to the port"

I know the power is fine bought a new battery today is there anyway i can ensure other applications are not connected to the port?

[mickc]

try multiprog

[puca]

yes as mickc said you need multiprog to power up elvis and set to phoenix and 3.5

[rewstar]

try multiprog

using which tab?
Thanks

yahah
got my ATR
used Multiprog and using the MPset tab pressed Phoenix 3.58MHz
Leaving Multiprog open

Then went to GUP and pressed reset and it read my ATR.

Cheers Guys now the next step... will prob be back on here in an hour or two when i cant figure it out again haha

[rewstar]

Ok i got my EMK from my HSN (thanks INFO)
And it looks something like this


CBS1S2S300000XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXX

Do i just copy this whole line and put it in GUP loader?

If so which section do i put it in?

-String to Send to card
or
-Logged data to Send to card

im assuming logged data but i want to be sure.

Cheers

[INFO]

Ok i got my EMK from my HSN (thanks INFO)
And it looks something like this


CBS1S2S300000XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXX

Do i just copy this whole line and put it in GUP loader?

If so which section do i put it in?

-String to Send to card
or
-Logged data to Send to card

im assuming logged data but i want to be sure.

Cheers

whole line and Logged data

[rewstar]

whole line and Logged data

Cheers again INFO.

EMM Successful