dont think u can share select cards mate
Hello, All
I need help with SmartWi splitter.
Just had my new card splitter .
I tried to use my SmartWi with my three
boxes, but it doesn't work at all.( Strong 4800 II,Humax 5410 Z & Coship 5110 D ).
Then I installed delay zip for SmartWi, no luck again.
Next I tried 2x Humax 5410 Z & 5400 ,start working for 4 or 5 min, after stop for 1 min or 30sec and so on.
And : message: service not running or scrambled & then start working again on both boxes after short delay.
Any advise will be appreciated.
Regards
VLADI.:
Look Here -> |
dont think u can share select cards mate
its a v5 card so it should be able to be used in a card splitter isn't there a setup procedure for these before you can use them
IF IT DONT WORK USE A BIGGER HAMMER
Bookmarks