The more I read, the more unclear it becomes.
I have a standard austar dish pointed at I presume Optus C1. (am still recieving Austar from it)
I have installed a dreambox 500s and managed to ftp the Optus C1 xml file.
Followed the instructions on several sites, but I do not get sync or lock, hence when I do a manual scan can not find any services.
Can anyone please help
Thanks
Look Here -> |
Dreambox tuners are more temperamental and the dish has to be more fine tuned then other receivers so that could be your problem, you might have to fine tune your dish
two common LNB setting are
LOF/L: 10700
LOF/H: 10700
Threshold: 11700
or
LOF/L: 11300
LOF/H: 11300
Threshold: 11700
Single frequency LNB usually.
Either 10700 or 11300.
Try both of them. Easy if you look on the LNB of your dish, it will have the L.O.Freq written.
Have you tried scanning 12407V 30000 2/3 to see if you can scan the tuning pattern for Optus C1?
Do Austar use dual frequency LNB's?
Ok, I have a satellite finder, and can do, but would like to exhaust my other avenues before moving the dish
Thanks
If you have a Universal LNB, try:
LOF/L: 9750
LOF/H: 10600
I think I should go onto my roof and check the LNB.
Will be back soon
Some of the label was damaged here is what I found:
LO 10.7
Frequency 11.7-12.75
Twin Digital LNBF
Here are the current settings and still no lock or sync
LNB L:10700, H:12750 Threshold:12750
Frequency 12407, INV unchecked, FEC 3/4 horizontal, Symbol Rate 30000,
SNH 69%
AGC 83%
when i change the LNB ferquency on a dm500s i usually have to do a reboot for it work.
Bookmarks