Area I'm relating too
Has anyone had any luck getting one of these suckers to talk to Mr White via the VCP Mode.
Re-:What setting did you use as in what type of card did you select from the list and did you use any other delay settings and alike....
Been Playing with GUP but just balls up the ATR seems to pickup when reset but after locking all falls over....
Cheers
Bigfella
Last edited by bigfella08; 05-06-10 at 03:38 PM.
Look Here -> |
Area I'm relating too
I use 3.3volts but thats not the problem.
When you are in VCP mode then, open GUP.
When GUP is opened have a look down the bottom at byte delay.
It will have value of 0 (zero). Change this to 10.
Click reset and you are in business.
bigfella08 (05-06-10)
Thankyou Shlocker....Works a treat
A hell of a lot slower than the Phoenix via the serial on XP
But saves a trip to the shed.....
I played with the Byte delay in GUP and on ten (10) it works but takes forever (45min)
So I tried changing things a bit So I set the VCP Settings to delayed write and GUP byte delay to one(1) and it worked so much faster about 10 mins not as good as the old phoenix on Xp but its improving....
I have the settings similar to you as shown on post. Only difference is the voltage.
Gup byte delay on 10.
Bin is loaded in about 10mins, so maybe its your computer???
Bookmarks