Strong SRT4658X power supply

[Min]

I have stuffed the power supply in my unit and am now after a new 1 or maybe some ideas as to how to fix this 1.
If anyone knows where I can get 1 from please post here.
Or
If anyone know the values of the components of the power supply please post here also.

It shouldn`t be a major problem as I only hooked up a wire to ground and 1 to 22volts then the hole thing just stopped.

Any ideas welcome and appreciated.

Cheers
Min.

[bulbous]

I would expect a 'fuse resistor' to be open circuit, something easily found with a multimeter. First check if there is any activity at all in the supply by looking (metering) for any voltages on the board. Then look for a low-value resistor open-circuit.

Give the board to someone with experience if you have no clue - and be aware that voltages exist on the supply primary side which can and will kill you.

[Sasho]

READ AN ELECTRONICS BOOK OR STUDY UP ELECTRONICS IT WILL HELP.
I know because it comes in hand to understand electronics when thing go wrong like that. That's why i did an course in avd. electronics know i love it.

[oscillator_1]

READ AN ELECTRONICS BOOK OR STUDY UP ELECTRONICS IT WILL HELP.
I know because it comes in hand to understand electronics when thing go wrong like that. That's why i did an course in avd. electronics know i love it.

So does the course you have done help you to answer MINS question ???

[Rocket]

You could try the electronics forum. But as stated above if your not sure of what you are doing get someone else to look at it. Power supplies CAN KILL.

[rievax]

Hi,
How did you connect to the 22 volts? Maybe you made a solder bridge.

[Min]

Hi,
How did you connect to the 22 volts? Maybe you made a solder bridge.

No, no solder bridge. Thats 1 thing I always make sure of.
I know power supplies can kill. Hopefully sometime this weekend I`ll get a chance to do some back tracking and see what could of went bad.