Multiswitch/ diseqC switch issue

[beer4life]

As I said. It works well with all my other gear. It's just the Strong won't control it. I know the Strong DiSEqC works because it operates a Moteck directly.

This is how it works with 4 dual standard LNB's, not Universals.
Port A/B - Tone A, 0Hz
Port C/D - Tone A, 22kHz
Port E/F - Tone B, 0Hz
Port G/H - Tone B, 22kHz
13V & 18V for polarity switching.

Well try this with your switch:-
For the Strong.
LNB Power...ON
LNB Type ...Single
LNB Freq......10700
DiSEqC Switch......1.0 / 1.1

.........22KHz...Committed...Uncommitted
Sat 1....OFF...........1............1
Sat 2....OFF...........2............1
Sat 3....ON............3.............1
Sat 4....ON............4.............1

[vk6xlr]

SMS 9949 NF

And the point of this photo is ?????

Well try this with your switch:-
For the Strong.
LNB Power...ON
LNB Type ...Single
LNB Freq......10700
DiSEqC Switch......1.0 / 1.1

.........22KHz...Committed...Uncommitted
Sat 1....OFF...........1............1
Sat 2....OFF...........2............1
Sat 3....ON............3.............1
Sat 4....ON............4.............1

Been through all of that already. Even before I posted my original question.
Hence why I asked the question just in case there was some trick to get it going.

[irdeto2engineer]

I have 8 ( and additional terrestrial in ) 16 out multiswitches.

[vk6xlr]

I have 8 ( and additional terrestrial in ) 16 out multiswitches.

Well, that's helpful, isn't it!

[nfnovice]

I have 8 ( and additional terrestrial in ) 16 out multiswitches.

I guess That would be a 9 in and 16 out..
what is one off them worth in AU$?

[irdeto2engineer]

I guess That would be a 9 in and 16 out..
what is one off them worth in AU$?

$250 delivered anywhere in Australia

[beer4life]

Been through all of that already. Even before I posted my original question.
Hence why I asked the question just in case there was some trick to get it going.

G'Day,
Perhaps I should have suggested this earlier.
Since you are using Twin/Dual output LNBs, the 22KHz serves no useful purpose. It is possible that it in fact interferes with the tone switching.

Kindest Regards, " The Druid ".

[vk6xlr]

Perhaps I should have suggested this earlier.
Since you are using Twin/Dual output LNBs, the 22KHz serves no useful purpose. It is possible that it in fact interferes with the tone switching.

Obviously you're not looking at the multiswitch correctly.

Of course the 22kHz serves a purpose, as per this table:
Port A/B - Tone A, 0Hz
Port C/D - Tone A, 22kHz
Port E/F - Tone B, 0Hz
Port G/H - Tone B, 22kHz
As you can plainly see here, 22kHz switches between A/B and C/D on the 'A' side and E/F and G/H on the 'B' side.

And as specified before "My Octagons, Dreamboxes and Unaohm S22+ Satellite meter operate the switch correctly" My new Relook 400s works perfectly too. So it's the Strong that can not operate it correctly.