-
Junior Member
- Rep Power
- 198
- Reputation
- 10
Jaycar phoenix type sc reader/reprogrammer (KC5342)
Hi ,
I have this Jaycar phoenix type sc reader/programmer (KC5342) . Just wanted to to know if it can be as a reader for gamma card for sharing.
Thanks
Tican2
-
Junior Member
- Rep Power
- 200
- Reputation
- 14
... not sure about the KC5342? ... I presume its a MKI?
... if so, it should be OK provided you can put it into phoenix mode ...
But many members here use the KC5361 devices and most of the time they work well ...
... I say most of the time because the RS232 interface is not always implemented to spec on different receives and their associated serial ports. As a result there are some 'mods' you ?might? need to make to your JayCar for it to work reliably ...
... there are numerous posts on this subject in this forum ... so don't be afraid to 'search'
Junior Member
- Rep Power
- 198
- Reputation
- 10
Thanks eyesee . My programmer is MKI . I used it before for goldie/silver. I am aware of the mod of MKII but I would like to know if MK1 works.
Thanks
Cheers,
tican2
Junior Member
- Rep Power
- 200
- Reputation
- 14
... have not seen the cct diag for the MKI - but from the receiver side all that's required is correct level RS232 (MAX232) and a good (stable) power and clock for the card ...
I think the MKII had some additional features for programming ... the reader function is most likely same - does it have 2 crystals (3.57 and 6 meg)?
... perhaps some of the other members have direct experiance they could share with you
mk1 works fine I have been told.
Jaycar MK1 is working fine for me.
Junior Member
- Rep Power
- 198
- Reputation
- 10
Thanks Dave001 and Z80 . Good to know that I don't have to spend extra $$ to get MKII
Cheers,
tican2
hey tican2 - somebody gave me an old jaycar kc5342 just yesterday
I got it powered ok - now what can I use it for ?
Junior Member
- Rep Power
- 198
- Reputation
- 10
U can use it to program EEPROM of goldies or as a phoenix card reader.
thank you tican - a whole new world of pain
- will give me sumthin to sink my teeth into
phoenix card reader - i have seen (and ignored) in the CCcam stuff - so I can start there
After that what is the best program to program a goldie ?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks