l had same problem in different receivers, have you tried in a another receiver?
Power off STB insert CAM then power back on may also work.
Cheers
Bubba
Hi
I tried to upgrade my xcam using 'xcrypto_125_card' and a Funcard, the cam was a xcam 1.04.
Everything seemed to go well, I re-initalised the cam and the receiver showed it as a 'xcam module' (it used to refer to it as a 'xcam 1.04' before the upgrade) but when I try to go into the xcam menu on my receiver it just says 'please wait' and never displays anything.
I don't have a CAS to try to talk to the cam directly, thats why I used the Funcard files.
Any ideas?
Thanks
Look Here -> |
l had same problem in different receivers, have you tried in a another receiver?
Power off STB insert CAM then power back on may also work.
Cheers
Bubba
I have tried the power off of the receiver etc but that didn't work.
I don't have another receiver with a CI slot to try it on )c:
Which receiver and firmware version are you using?
XCam works in my Strong box and gets stuck with "please wait" in other STB's and have to reboot.
Last edited by bubba1234; 19-07-10 at 01:06 PM.
My receiver is a Strong also - I think its something like a 4658
Last edited by bubba1234; 19-07-10 at 05:17 PM.
My receiver is 1.24 too so I might have to look at getting a CAS to fix this issue
Bookmarks