Originally Posted by
Geebs
Gordon,
Apologies for re-opening this thread. If you haven't already sorted it, I have a few ideas that might help.
I have found that ash accumulates in the secondary combustion chamber. This is the chamber above the fire pit. When you open the door and look up there is a grate full of holes. It is held in place by a couple of twitches of wire. Cut them with some side cutters then you can scrape the ash out of the chamber. Wire the grate back into place and you are good to go.
Also, it helps to clean this grate from time to time, just give it a brush when the burner is cold. That will remove any ash buildup there.
Failing all that, I do have the original operating manual. I could scan a page or two that has the adjustment for the "Set and Forget" mechanism.
cheers,
Geebs
Bookmarks