Do you have the correct OCX files installed and correctly registered
hey
im trying to create an ausgold silver card for aurora
i have been following a guide for programming ghost gold and silver
and ausgold silver,
when i get to the point of programming the ausgold.hex into the PIC
the verification 'fails', i have tried heaps of times,
can anyone tell me why it fails?
also does anyone have a saved file of the data that needs to get programmed
into the eeprom with the ausgold card writer?
thanks heaps for any help
(i have a jaycar programmer)
Look Here -> |
Do you have the correct OCX files installed and correctly registered
Democracy & Ignorance = A Winning Combination
if its code protected it wont verify
Try IC prog 1.05A.(assuming XP)
Need to set up driver under menu tab .
Going from memory,
Switch out on jaycar to program the PIC/select the correct chip cfg
16f877(silver) xt oscilator and untick all the fuses.
You need a valid set of details to load.
Last edited by sublib25; 10-08-10 at 11:20 PM.
yeah the ausgold card writer app works i just not exactly sure what to put in there haha
and how do i know if its code protected? its a new blank silver card and the files were off austech. ( unless theres a problem with the ausgold.hex file i downloaded)
yeah icprog is all set up on xp, i have done ghost gold cards with it.
Bookmarks