Reply With QuotePress the OK button then hit the red button until the the tuner list comes up then select the desired tuner.
Leroy
F-9000HD PVR Changing Tuners via Remote?
T1 LNB in = Ku LO's.
T2 LNB in = C band LO 5150
(TUNERS set to SEPARATED for each band - sat search and result).
Installed C band channels on T2, uses a positioner and each required Sat is stored (i701 through to AS5), saved and required channels loaded.
Remote 'OK' button shows channels for Ku and C band, changing from here keeps all channels (C and Ku) to T1.
T1 bears Ku stuff, uses D1.2 (motek) commands to a 'switch' which accepts those commands, as several LNB's are used on a T90! - Result, all good on all sats and smooth auto changing for T1's Ku lot (D2 to i701).
BUT how does one change Tuners from T1 to T2 to watch loaded C band channels?? Ie from Remote?!
I am leaning towards restarting altogether and loading C band on T1 then keeping T2 for Ku, ie 'swap', might be impedance issue.
| Look Here -> |
Press the OK button then hit the red button until the the tuner list comes up then select the desired tuner.
Leroy
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
Posting Permissions
Bookmarks