CCcam:no login ack

[barkerk]

I have a dreambox 518s running PLi image and CCcam 2.1.1
I am one of four clients talking to a dreambox server referencing a blue card.
The other three clients are successfully connected and receiving pictures. We all have the same CCcam.cfg file except for the username and password i.e.
N: server 12000 username password 01 02 03 04 05 06 07 08 09 10 11 12 13 14
I can successfully ping the server. I have tried three different versions of CCcam all without success. When I telnet my dreambox and run CCcam -d, I notice these three lines:
"CCcam: server started on port 12000"
"CCcam: newcamd server xxxxxx.dyndns.org:12000 user: xxxxx"
"CCcam: newcamd receive error: no login ack"
I have searched many forums and read volumes on the subjects of dreamboxes and CCcam, all to no avail.
Does anyone have any clues why I get the "no login ack" message?

[Fernbay]

Check upper/lower case of the login at the client & server (which I assume is either newcs or oscam?).
(You might also want to 'borrow' the N: line from a working client just for a quick test on yours)

(Moved post from 'dreambox' to 'emulators')

[barkerk]

Oscam has been a recent addition to the server due to lost channels. When I "borrow" another clients username, everything works OK. I am only guessing but suspect that since I am the first client to be added since the introduction of Oscam to the server there is a command line in Oscam that needs to be added to allow me access. I know there is a lot of information on the dreambox section of Austech about "Oscam and lost channels" so I will have to start reading it to see if I can understand what the problem could be.

[barkerk]

Success at last.
Even though the oscam.user file had been updated to include me and the server CCcam config file had added me as a new friend, it would appear that the dreambox server needed to be rebooted for these changes to take effect.