Help with Jaycar Smart card/Programmer MK2

[boggo007]

Need help to a mod, when I insert a card in the MKII (KC5361) after few secconds it thinks the card is not inserted when in fact it is, the message I get is card ejected slot = 0. When I eject the card I get externalreader card detected.

[Min]

re-check all the soldering with a magnifying glass for bridging. Also check that all the components are in the correct locations.
Just wait abit and someone with more experience will help you out.

[boggo007]

I have done that, the testing results are all ok.
Thank u for your advice.

[boggo007]

It amazing what you can find when you start to read.
Thanks for the thread Building a lean & mean Jaycar Phoenix and many more, used the spare inverter IC3f to fix incorrect "card reset". close thread.

[LeroyPatrol]

There is a wealth of information on this site about the Jaycar readers. You prob need to give a bit more info about your setup and what you're doing if you need a bit more assistance.

Leroy

[boggo007]

LeroyPatrol, point taken, this was a brand new construction KC5361 kit which I forgot to state.

I am after a file to program a blank standard Gold card from Jaycar, ie the micro Pic and the EEprom, to complete the final testing of this new kit.
Can someone help.

[LeroyPatrol]

LeroyPatrol, point taken, this was a brand new construction KC5361 kit which I forgot to state.

I am after a file to program a blank standard Gold card from Jaycar, ie the micro Pic and the EEprom, to complete the final testing of this new kit.
Can someone help.

Plenty of info on gold card programming on this site. Just do a search.
Here are some useful bits





Cheers,
Leroy