Press Setup (remote control).
Choose System Settings.
Press Select (remote control).
Key in the pin 0611 (remote control).
Press Select (remote control).
Hi Guys, I was wondering if there was anyone who knew how to change the lnb settings on a f*x box. I triedf going into the settings and changing the lnb as my sat obviously has a different setting to the box but could not figure out how to change it - not sure of there is a pin code or what? I guess failing that I may have to change the lnb on the dish is that right?
Look Here -> |
Press Setup (remote control).
Choose System Settings.
Press Select (remote control).
Key in the pin 0611 (remote control).
Press Select (remote control).
Does it have a Universal setting?
I tried changing the lnb settings but couldn't work out how to do it? When I go to the stystem setup another screen comes up saying installer setup with the following menus
1 EPG SYSTEM
2. MODEM SETTINGS
3. RF OUTLETS
4 NEW INSTALLATION
The area where you seems to be able to make changes is in new installation however the settings say
Frequency (Mhz) 626
Symbol Rate 6.95
Modulation 64QAM
Region ID 00
I do not see how or where I can change the lnb settings (But no doubt I have missed something as I am not very tech savvy) I also noticed on the box there is a red light saying signal locked - no idea if this means anything.
As stated in another post I made I used to have a humax setup in the old days and I am getting TVSN and Imparja - I would have stuck the legit card in my hummer but I have lost the remote and therefore can't make changes to the lnb. When I stick the legit card into the hummer it just says service scrambled anyway.
Just not sure of what to do next - any help would be greatly appreciated!!!!
You are in the wrong Forum Dude,You are talking about Cable box....
Bookmarks