Is the Switch in the Correct Position (i.e IN to program the Eeprom, when you get to that step)
otherwise check your settings,
Good Luck
hi
when trying to run the wizard on ic prog with a gold card on a jaycar programmer it comes up with a "programming not supported" error when it tries
to program the eeprom.
does anyone have any ideas?
Look Here -> |
Is the Switch in the Correct Position (i.e IN to program the Eeprom, when you get to that step)
otherwise check your settings,
Good Luck
Become a Premium Member and support the Austech Forum
I gave up using jaycar problem after problem got a mastera and worked first go.
Bookmarks