Do you have the Id number of the box and software version before you flashed it?
and what model is it
5400
5400Z
5410
5410Z
Adobe.
Hi Guys,
I have been trying to update my 5400 firmware and i think I've killed my box!
I had an E-iD error, so I ran an iD change patch which seemed to work in that i could send patches to the box. When I then ran the patch, the update ran through ok, but when I reset, i got to an rA, then it seems to have stuck there. Further uploads run through correctly, but when I re-boot I get the same problem - stuck in rA section of boot.
HELP!
Cookoo
Look Here -> |
Do you have the Id number of the box and software version before you flashed it?
and what model is it
5400
5400Z
5410
5410Z
Adobe.
Thanks for the reply Adobe,
model 5400, id 0025.0200.
used Formulav3 which allows id number input, all flashing went in ok, then won't boot past rA.
Cookoo
I think your going to need a Z loader and then reflash the unit. Is your unit Mic or Hic?
Adobe.
I fixed it - thanks to a little patch on humax.zone.
5400N_0025.0200.hdf
thanks
cookoo
HI guys i dont have a luck with my humax i download the new software 3.4 toh 11 no luck plz any help thanks
What model Zooloo, if it ends in Z then as Adobe says you need to use a Z-board to load the loader firmware which gives you access to flash the firmware
Then you can use HUMAX ZORRO TOOLBOX V2 to do most things, ie: change id, load firmware, add keys ect, ect..
sory guys is humax 5400 with no z not working in whities
to be honest i try all the firmware on the link still no luck , and is the standard firmware were to get it from thanks
look for it at humaxdigital.com
Omega is nothing there another link plz ,, there nothing for 5400
Bookmarks