I was wondering if anyone else has upgraded their Azbox with the latest RTI firmware.I have found it to be excellent,but cannot get the internal card reader to read my goldie.
Anyone have any ideas?
BTW ,these boxes (premium plus) also have a noisy fan and I was able to solder a 24 ohm resistor to the red cable and this has made the fan much more quieter.
Look Here -> |
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
I have a usb with original firmware that I can boot directly and it does read the card.
I doubt it. I don't have any to try anyway.
Maybe no card reader support with RTI firmware? Another thing, I1 is getting old so I'd be surprised if the EMU supports it.
The factory firmware isn't that bad and actually works fine. Little slow on clearing CS channels in the past, not sure now, but all in all it works, blindscan is not the fastest, display's 4:2:2 feeds and reads goldies.
Leroy
Last edited by LeroyPatrol; 28-08-11 at 07:47 AM.
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
I dont have any IR2 cards either.
I know the spazeversion of e2 has card reader support
ok I tested my ir2 card this morning and it reads and performs fine, that is with the E2 Spaze Fix.
Just running oscam.
jgarg (28-08-11),LeroyPatrol (28-08-11),Woodie (30-08-11)
Woodie (29-08-11)
I dont have a 5.7,
only got an early card
Bookmarks