-
Junior Member
- Rep Power
- 0
- Reputation
- 10
Ness D24 Installercode reset
Hi, I have a Ness D24 alarm system and need to program new remote controls (RK4). To program I need the Installer Code, which is unknown as the Installer code was changed by the previous owner/installer. Is there anyway to reset the Installer code to the factory setting code without affecting all other setups? Thanks
-
To reprogram remotes there are about 3 different things that need to be done. Get the manual because it has to be the MOST convoluted process of any panel. When you have the manual you will see that getting into program mode is very easy (no code needed)
Junior Member
- Rep Power
- 0
- Reputation
- 10
Thanks Watchdog. I have both user's manual and Installation & Programming manual. The Ins & Programming manual says Installer code is needed to performs radio key (remote control) programming.
Yes but you can get into programming then set your own installer code. Look at the book.
power down panel and power back up with the panel tamper open circuit you will now be in program mode. you can then change master and installer code and yes it is the book
Junior Member
- Rep Power
- 0
- Reputation
- 10
Many thanks to all. One more question, if power down panel and power back up, would this reset all existing settings to factory default?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks