Results 1 to 2 of 2

Thread: gbox positioner reading e2 only

  1. #1
    Junior Member
    Join Date
    Oct 2011
    Location
    newcastle
    Posts
    1
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Rep Power
    0
    Reputation
    10

    Question gbox positioner reading e2 only

    hello everyone, i have a 3 metre dish have 1 actuator everythings new ive put new cable in rg6 quad shield my lnbf is a mti linear dual voltage. my rxr is a mediastar 9100hd dvdt..my situation is i cant move very far with my vbox without it bringing up e2 then my actuator stops moving ,i have checked all the cables to the vbox etc m1 and m2 are fully connected along with the other 2 wires for the sensor are also connected and are all making contact ,ive also checked the reed inside the actuator which is also connected .i was wondering if anyone can help me ive moved the dish alittle by using a 13.8volt power supply when i use that i dont need the sensor wires only the m1 and m2 but i cant see what satellite im on without the numbers working ,i need to know if someone can help me with this problem .regards sam stepenson nsw.



Look Here ->
  • #2
    Junior Member
    Join Date
    Jun 2011
    Posts
    224
    Thanks
    25
    Thanked 26 Times in 14 Posts
    Rep Power
    166
    Reputation
    140

    Default

    I have a Gbox positioner..

    Normally E2 error is when the sensor reaches it's limit.

    Have you properly tested the Reed switches with a multimeter instead of just checking that its connected ?

    Do you have any Soft Limits set on the positioner itself?

  • Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •