Generally wedge the door. Then free drill starting with a shorter drill bit.
Interested to hear other people's ideas about drilling cable raceways in external doors
for mortice locks.
Personally I free drill them with the door braced on its lock and hinge face. However, I am also aware of the SDC raceway drill and doing it with custom drill bits but, curious to know if there are other ideas out there?
Look Here -> |
Generally wedge the door. Then free drill starting with a shorter drill bit.
I use a one piece auger drill bit so that it has no flex in it. I have used speedbors/spades but have to make sure not to flex them.
I try not drill a hole any bigger than 10mm so that the door is not structurally weakened with a hole too big in diameter.
phone my locky and get him to do it
Bookmarks