-
Junior Member
- Rep Power
- 191
- Reputation
- 145
Tecom v8 activate flag or relay via code to lcd ras
hi there this ones got me stuffed i can do quite complex programming of the tecom v8 but this got me stuffed
Tecom v8 activate flag or relay via code on lcd ras
thanks in advance
what i am trying to do is set a relay for about 5 seconds to remove power to smoke alarms to reset them
Last edited by freerider_aust; 29-06-23 at 07:08 PM.
-
Junior Member
- Rep Power
- 0
- Reputation
- 30
tecom reset smoke detectors
from memory there was a way to program relays that you want to manually cycle. i cant remember exactly where but i do remember that after its done you press the * key at any time on any keypad for a few seconds cycles the relay for a short period.
Junior Member
- Rep Power
- 191
- Reputation
- 145
problem solve i didn't add a door group to a code only user as most of my control is done using smart door controllers which i had to have door groups assigned
thank to all who looked
The Following User Says Thank You to freerider_aust For This Useful Post:
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks