You need to put your multimeter across -ve and NO1 to check for voltage.
I have a Hills 128 with Comnav installed.
I'm trying to check the output of the 2 relay.
I've place a link for J11 between C and 12v+
Hooked up C1 and NO1 to a multimeter,
Set the activation even to Box Temper.
Open the alarm box and no voltage is detected on the multimeter.
Can someone let me know if I've missed a step.
thaanks
Look Here -> |
You need to put your multimeter across -ve and NO1 to check for voltage.
ok let me rephrase my problem.
What do I need to do apart from calling an installer to get the relay output of the comnav unit to trigger on an event to run 12v lightbulb.
Thanks
Bookmarks