Hey all. I need to get my sat box hooked up to my PC. The only cable I have is a null modem cable, which is the right one, but it happens to have a printer port plug on the other end! Are there any fixes/cracks (no, not with a hammer) that I can use to make the computer think that the printer port is a com port?
Mucha appreciated all. Thanks, Mick.
Look Here -> |
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
How else can I fix my dead 4658x?
Is this right for a COM port to Sat Box cable config?
pin 2 ...to... pin 3
pin 3 ...to... pin 2
pin 4 ...to... pin 6
pin 5 ...to... pin 5
pin 6 ...to... pin 4
pin 7 ...to... pin 8
pin 8 ...to... pin 7
What did you do to your box kiddo? Do a google for null modem cable and then you can make one up.
Leroy
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
And solder I shall. I am too sleep-deprived at the moment, and this coffee isn't doing the trick, so tomorrow I'll have a crack at it. I tried to go from 1.17 on the 4658x to 1.04p, as I was having probs with the SelecTV card dropping out, and she went to 100%, and then turned off, and now I just get the 4 flashing lights of doom.
hardley normal has the plug i think but yeah do it ya self
Bookmarks