Hi Everone,

This may seem like a stupid question but does anybody know where the power fuse on the AB IPBox 9000HD (same as Cuberevo 9000HD) is located?

According to the manual the power supply is protected by a separate internal fuse, and the power supply circuit board has a warning printed on it to always replace the fuse with another of the same type and rating. I can see nothing on (or under) the board which even looks like a fuse.

My box went completely dead after I switched the power off then back on to clear a software hangup. Power is getting as through the switch to the circuit board but that is as far as my electrical/electronics knowlege will take me.

Any advice greatly appreciated