If you set it up as before I would say it won't work as the cards are now locked to the box so it will not be easy to if at all possible.
I haven't been on here for a long time and have lots to catch up on. I want to share my Spongbob card on 2 decoders at home, I have some gear that I used for a short period of time ages ago and it worked fine. My setup was as follows: Spongbob in phoenix/smart mouse into serial port on PC running server software, wired network connection to PC running client software, 2 Jomac interfaces into serial ports on client PC into Atlas and ADB decoders. Can I use any of this gear with Greywolf or some other software to share my card?
Any opinions/advice will be much appreciated,
Oberg.
Look Here -> |
If you set it up as before I would say it won't work as the cards are now locked to the box so it will not be easy to if at all possible.
It's hard to make a come back when I havn't been anywhere
I finally got my head together, now my bodies falling apart.
為什麼不做你被塞滿
Ok I've done a bit more reading and here is what I have found out so far please let me know if I've got it wrong.
Spongebob in a phoenix card reader connected to server PC (windows XP) via serial port, greywolf running as server (run multiple client versions for the number of decoders you want to share the card with, in my case 2). This is where I am unsure of what comes next, what interface to use to interface with the decoders and what type of decoders can be used.
I'm about half way there I think.
Oberg.
original payed sub cards only work in the providers set top units due to firmware changes a couple months ago
Well that makes it a bit hard doesn't it? What about a providers unmarried ADB box or are you saying the Spongebob just wont work in anything other than the box supplied with it?
Oberg.
Bookmarks