Hi,
After a bad file programming or I don't know!!!! I can't progam a silvercard getting error just after writting flash : " write eeprom int ( check error) "
and with icprog or other? I got error at 0000h or resseting fails.
Any help?
Look Here -> |
Dear Hannibe,
I use the 2 speeds!! same error!
Is there a program that can tell if the silvercard is wasted and it can't be repaired!
Thnanks.
what programmer are you using? if its a usb programmer this can sometimes throw that error when writing to the pic due to low power voltage
Also like to know what programmer are you using...?
If using a Jaykar MKII:
make sure the ICprog driver is installed....(if needed)
then just make sure all the necessary settings & steps are correct..... (most important)
what OS are you using (Windows XP or other) ?
Last edited by OSIRUS; 14-03-13 at 09:23 AM.
Become a Premium Member and support the Austech Forum
Dear all,
I'm using an infinity usb unlimited having this
and also a fun programmer on lpt1 having resetting error or pramming at 0000H error with ICPROG!
I'm using xp sp3 os with icprog drivers for windows 2000 compatibility installed.
Bookmarks