Press Setup on the remote
Go to System Setup -Press Select
Go to System Settings - Press Select
Go to Picture Settings - Press 0611 - then Press Select
Go to LNB Setup - Press Select
(Change LNB settings) - Go to save New Settings - Press Select
i want to change my lnb from 11300 to 10700 but i can not access the install menu on my pace ds250 box
have done the setup/system settings/0611/select but it does not go to install settings?
any ideas please
Look Here -> |
Press Setup on the remote
Go to System Setup -Press Select
Go to System Settings - Press Select
Go to Picture Settings - Press 0611 - then Press Select
Go to LNB Setup - Press Select
(Change LNB settings) - Go to save New Settings - Press Select
Become a Premium Member and support the Austech Forum
tristen (30-05-13)
If your still having problems try this .....
when the wrong Lo frequency is set you can't get into the setup menu by pressing set up on the remote....
it just sits there saying 'no satellite signal found' (or something like that)
so, if you press the tv guide button on the front of the box and then press the set up button it lets u get into the settings...
then ....
Go to System Settings - Press Select
Go to Picture Settings - Press 0611 - then Press Select
Go to LNB Setup - Press Select
(Change LNB settings) - Go to save New Settings - Press Select
Become a Premium Member and support the Austech Forum
tiny56 (29-05-13)
ok thanks all sorted now
i had already done exactly what you stated and it did not work
i think i entered the 0611 to fast - entered slower and it worked
OSIRUS (29-05-13)
Bookmarks