rgh 2.0 phat falcon xbox

**mastaola** · 01-08-13, 03:28 PM

Hi just got a quick quiestion trying to do rgh 2.0 on a phat falcon 14719 dash.I can a read the nand no problems but when i go to write ecc or write nand back on to console i get errors all the way threw.Ive checked solder connections and everything seems to be ok.

Does anyone know what this problem could be,any help would be great.

cheers

**loanrangiel** · 02-08-13, 02:11 PM

If you are getting the flash controller not found or similar then its your wiring, try using a different ground point like the chassis.

**mastaola** · 06-08-13, 01:54 AM

Ended up using a different program and i can now write my nand back on to the console,but still got a problem and cant boot into xell. Coolrunner is gltiching but all i get is a black screen.

Any ideas

cheers

**loanrangiel** · 07-08-13, 01:16 PM

Numerous reasons for not glitching correctly, wire length, CR timing etc. They are a PITA unless you do them on a regular basis and know what works - i gave up on a jasper but slim was easy.

**mastaola** · 07-08-13, 10:14 PM

Yeah they are PITA.The only thing i dont get is i dont get any errors when writing ecc to the console,and the CR seems to be glitching.The only problem i noticed when trying to boot into xell is that green power button on the xbox doesnt flicker it just stays on.So just trying to figure out whats causing that problem.

cheers