Run CCcam from the console with -d so see what is going on.
Trying to card share between 2 DM500s, PLI Ionite, CCcam2.0.8. C and F lines entered. LNB in master out again to client, ethernet cross over cable
Ligit ND$ card, only thing i can get on the client is TVSN
My question does CCcam have to be entered on the cardserver line as well?
PS, both boxes work well individually
regards Allover
Look Here -> |
Run CCcam from the console with -d so see what is going on.
By reading this, you have already given me control over a tiny slice of your mind
Covert, uuuhhh more information
regards Allover
post your cccam.cfg files for both your server and client.
Leroy
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
Log into your dreambox with a telnet client. I use a recommend putty (google it)
username root password dreambox (unless you changed it)
In the console after logging in run the following commands.
Press CTRL-C to stop CCcam and scroll back to take a look at any error messages.Code:killall CCcam CCcam -d
By reading this, you have already given me control over a tiny slice of your mind
CCcam status page might help you as well...
By reading this, you have already given me control over a tiny slice of your mind
Leroy
Ok On the client box i have
CLIENT
10#friends
26#
27 F:user1 pass1 1
28#
etc
FRIENDS
90#
91 C:192.168.1.3.dydns.org 12000 user1 pass1
92#
etc
Hope this helps
regards Allover
c lines wrong.
assuming 192.168.1.3 is the ip address of the DM with the card in it.Code:C:192.168.1.3 12000 user1 pass1
By reading this, you have already given me control over a tiny slice of your mind
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
Thanks all once again will double check every thing
regads Allover
Wet day in Melbourne! have been trying to enter the command killall CCcam, CCcam -d to determine why i cannot network the 2 DM500s
Using puttytel.exe. Can enter the login but cannot get past the password in this case still dreambox, any suggestions?
Still trying, will allow me to log "root" but when i try and enter password be it dreambox or admin it will not let me enter any keys
Just type dreambox and press enter at the password prompt. It will not give you any feedback that you have pressed a key. Thats the nature for telnet/ssh.
By reading this, you have already given me control over a tiny slice of your mind
Bookmarks