Whitey Humax Splitter Firmware Fix?

[statesmanjeff]

I Have A Few Humax That Have The Dreded Epoxy Over The M/board.
So I Cant Be Bothered To Attempt To Z Them.
I Have Purchased A Splitter (works With Whitey)for Another Application But Just Wanted To Know If I Used A Whitey In This Splitter And 2 Humaxs, One Good Firmware The Other Bad, Will The Bad Humax Read The Splitter Card And Operate Like The One With Good Firmware ??????

[LeroyPatrol]

this isn't answering your question but you don't need to have a dezedded humax.

Leroy

[statesmanjeff]

I Can Be Easily Confused.
Can A Humax With Wrong Version Firmware Still Update A Card Altho It Wont Show A Picture?
I Wanted To Try To Get 2 Humaxs Going Off 1 Whiteyusing A Splitter
One Humax Firmware Works, The Other Does Not.
Will The Splitter Make Them Both Show A Pic As This Place Does Not Have Internet And Needs To Be A Stand Alone.

[BillyGoat]

this isn't answering your question but you don't need to have a dezedded humax.

Leroy

He will have to deZed the humax if its got the 1.03 firmware and load the 1.05 original firmware.
There is a thread around here about it.

[statesmanjeff]

I Have De Zedded Heaps Of 5410z But Accidently Started On A 5400z Without Looking At It First.
It Was Only When 1.5 Wouldnt Load I Noticed The 2nd Cam.....
It Took The H208 Loader But That Was It.
Any Ideas. Do I Just Now Start Trying To Install Every System Id Firmware Till It Comes Good As I Didnt Get The Number Before I Z It.
Or Is There An Easier Fix.

[Jaz808]

Hang on, Original firmware = Good
Modded or TOH = Bad
Bad Firmware Humax = all ready de-zed, should be or how did it get bad firmware
So load original firmware on bad humax

[LeroyPatrol]

He will have to deZed the humax if its got the 1.03 firmware and load the 1.05 original firmware.
There is a thread around here about it.

Is 1.03 not just an earlier version? I'm not up with the Humax's and it firmwares.

Leroy

[fandtm666]

I Have De Zedded Heaps Of 5410z But Accidently Started On A 5400z Without Looking At It First.
It Was Only When 1.5 Wouldnt Load I Noticed The 2nd Cam.....
It Took The H208 Loader But That Was It.
Any Ideas. Do I Just Now Start Trying To Install Every System Id Firmware Till It Comes Good As I Didnt Get The Number Before I Z It.
Or Is There An Easier Fix.

go HIC10500-016.0600

this is the one i use after i have done a d-zed with the loader files i have

[puca]

yes both humax boxes will run via the card splitter i have 6 humax boxes running of my splitter
the card only works in 2 of them the other 4 show pics for about 3 seconds when the card is placed in each box

[puca]

here are 2 hic 06 and 02 they are the 2 main firmware for the 5400